Aluminum coil placement in workshop

Standard for aluminum coil placement in Signi production workshop
 
1.The aluminum coil is placed on the metal or wooden support frame with enough strength, and the support frame appears cracking or loosening. It should be withdrawn immediately for maintenance or replacement.
 
2. in the aluminum coil hoisting and placing, we should carefully support the good support, aluminum coil should be placed in the middle of the support frame, can not be biased. When the supporting frame has a backing plate, it should be checked to adjust the shim plate to the middle position and then slowly drop the aluminum coils.



3. aluminum coil should be placed neatly, no more yellow line, the width of the aluminum coil should be in accordance with the principle of near the end of the neat Huang Xiance put.
 
4. aluminum coil should be placed in double stacked when the width is in the lower layer, the narrow coil in the upper layer, the upper end of the aluminum coil does not exceed the end of the lower aluminum coil. Aluminum coils that are too small in diameter must be placed in the upper layer or placed separately.
 
5. aluminum coil placed at most can be stacked two layers, prohibit stacking third layers.
 
6. aluminum coil placed in the order and production order of import should be consistent, to minimize the number of ask to see the archives;

7. because the production needs to hang the lower aluminum coil first, the upper aluminum coil must move to the stable support frame in sequence, then hangs the lower level aluminum coil, finally restores the original place.